Documentation for the Simulation Editor
of the FRAMEwork System (FRAMES)


Title Page
Legal Notice
Table of Contents
Introduction
Requirements
Design
Quality Assurance and Testing
  

Quality Assurance and Testing of the Simulation Editor

FRAMES was developed under a quality assurance (QA) program that looked at the software life cycle: requirements analysis, design, programming, modification, testing, and implementation. A general description of this program is contained in the quality assurance and testing section of the FRAMES system documentation.

Part of the QA program involves testing each component to ensure that it satisfies its requirements. The requirements section of this documentation provides a list of requirements for the Simulation Editor. A test plan was developed with test cases that addressed these requirements. The table below shows how these requirements were addressed in testing.

Testing Matrix for the Simulation Editor Testing
 
Requirement Test Case
--- 01 02 03 04 05 06 07 08
1 X X            
2 X              
3 X              
4 X              
5 X              
6 X              
7               X
8               X
9 X              
10 X              
11   X            
12     X          
13 X              
14   X            
15       X        
16 X              
17         X      
18           X    
19         X      
20            X  
21               X
22 X              
23 X              
An Approach to Ensuring Quality in Environmental Software (Gelston et al. 1998. PNNL-11880)
  • Test Plan for the Simulation Editor
  • Status Report for Simulation Editor Testing
  • Test bed for Simulation Editor testing.

    • Battelle Logo
    Home | Security and Privacy | Contact Us