SFDBULKD | Dry bulk density of surface soil | ||
STAREA | Area ofthe waste site | ||
STAVAILW | Water-holding capacity of waste zone | ||
STAVTEMP | Average air temperature at the waste site | ||
STAVWINDV | Mean annual wind speed | ||
STCFACTR | Vegetative cover factor | ||
STCLOUD | Fraction of sky with cloud cover | ||
STCORRSC | Non-erodible area correction factor | ||
STCRUST | Fraction of surface area covered with a crust layer | ||
STDELTA_T | Length of time step | ||
STELEV | Elevation of waste site | ||
STKFACTR | Soil erodibility factor | ||
STLAT | Latitude of waste site | ||
STLCDELEV | Elevation of Local Climatalogical Data (LCD) Station | ||
STLENGTH | Length of site down erodible slope | ||
STLOCSUR | Surface roughness length | ||
STMAXTIME | Length of run | ||
STMAXWIND | Maximum wind speed at site | ||
STMINWST | The minimum waste fraction for which analysis performed | ||
STMNUMPRE | Number of monthly precipitation events | ||
STMOISTC | The volumetric moisture content fraction of the source zone | ||
STMPRECIP | Monthly precipitation amount measured at LCD | ||
STNUMDIS | Frequency of mechanical disturbances to site | ||
STNUMPRCP | Numberof days with 0.254mm precipitation | ||
STOVLFLX | Overland flux for a ponded case as fraction of total water volume. | ||
STPEI | Thornthwaite's Precipitation-Evaporation Index | ||
STPFACTR | Erosion control practice factor | ||
STPRECIP | 2-yr, 6-hr, precipitation event | ||
STRHMAX | Maximum monthly relative humidity | ||
STRHMIN | Minimum monthly relative humidity | ||
STROADS | Flag to designate type of road travel | ||
STRTDIST | Distance traveled over contaminated surface | ||
STRTNUM | Average number of vehicles traveling over surface daily | ||
STSAND | Percent sand in surface soil | ||
STSCSCN | SCS curveumber | ||
STSILT | Percentof silt on road surface | ||
STSLOPE | Slope of waste site | ||
STSSOL | Concentration of suspended solids in surface impoundment | ||
STSTORMI | Storm type index for location of waste site | ||
STTEMP | Temperature measured at LCD | ||
STTHICK | Thicknessof the waste zone | ||
STVEGFR | Fraction of surface area covered with vegetation | ||
STVSPEED | Mean vehicle speed at site | ||
STVWEIGH | Mean vehicle weight | ||
STWHEELS | Mean number of wheels per vehicle | ||
STWINDHT | Height above ground of local wind measurements | ||
STWINDV | Mean monthly wind speed at LCD | ||
WZDBULKD | Dry bulk density of waste zone |
STAIRSPC | The volumetric air content fraction of the source zone | ||
STAIRSPC_TIM | Times for air space-time pairs | ||
STAIRSPC_NUM | This is the number of different airspace percentages | ||
STCLEAN | The initial thickness of the clean layer | ||
STCLEAN_TIM | Times for cover thickness-time pairs | ||
STCLEAN_NUM | This is the number of different clean layer thicknesses | ||
STDARCY | Darcy infiltration rate | center>qw | |
STDARCY_TIM | Times for infiltration-time pairs | ||
STDARCY_NUM | This is the number of different infiltration rates | ||
STTOTPOR | The total porosity fraction of the source zone | ||
STTOTPOR_TIME | Times for porosity-time pairs | ||
STTOTPOR_NUM | This is the number of different total porosity percentages | ||
STWATR | Water erosion rate | ||
STWATR_TIM | Times for water erosion-time pairs | ||
STWATR_NUM | This is the number of different water erosion rates | ||
STWIND | Wind erosion rate | ||
STWIND_TIM | Times for wind erosion-time pairs | ||
STWIND_NUM | This is the number of different wind erosion rates |
CLDIFCO | Grout Diffusion Coefficient for each contaminant | ||
CLHLC | Henry's Law Constant for each contaminant | ||
CLKOW | Octanol-water partitioning coefficient for each contaminant | ||
CLKTYPE | Contaminant type for each contaminant | Param | |
CLLAMBDA | Decay/degradation constant for each contaminant | ||
CLSPECACT | Specific activity for each contaminant | Param | |
CLVAP | Vapor Pressure for each contaminant | ||
CLWM | Molecular weight for each contaminant | ||
FSCASID | CAS ID for each contaminant | Param | |
NDS | Number of daughter products for each contaminant | Param | |
NUMALLCON | Number of all contaminants (parents plus progeny) | ||
NUMCON | Number of contaminants (parents only) | ||
STINVEN | Inventory quantity for each contaminant | ||
STORGCON | Concentration of organic contaminants in the organic phase | ||
STSOL | Aqueous solubility for each contaminant | ||
STVOLRAT | Volatilization ratio used for control of volatilization |
STKD | Kd for each contaminant | ||
STKD_TIM | Time for Kd-time series | ||
STKD_NUM | Number of different Kd values used |
STGLASS | Glass dissolution rate | ||
STGLASS_TIM | Times for dissolution-time series | ||
STGLASS_NUM | This is the number of different glass dissolution rates | ||
STSURFVOL | Surface to volume ratio of the grout monolith | ||
STSURFVOL_TIM | Times for surface/volume-time series | ||
STSURFVOL_NUM | This is the number of different monolith surface to volume ratios |
STLEACH | Known leaching flux rates | ||
STLEACH_TIM | Times for flux-time leaching series | ||
STLEACH_NUM | Number of known leach loss flux rates | ||
STOVL | Known overland flux rates | ||
STOVL_TIM | Times for flux-time overland series | ||
STOVL_NUM | Number of known overland flux rates | ||
STSUSP | Known wind suspension flux rates | ||
STSUSP_TIM | Times for flux-time suspension series | ||
STSUSP_NUM | Number of known suspension flux rates | ||
STVOLAT | Known volatilization flux rates | ||
STVOLAT_TIM | Times for flux-time volatilization series | ||
STVOLAT_NUM | Number of different volatilization rates | ||
STSOURCE | Known flux rates for a source to the waste zone | ||
STSOURCE_TIM | Times for flux-time source series | ||
STSOURCE_NUM | Number of different flux rates for a source to the waste zone |